| Customization: | Available |
|---|---|
| Certification: | ISO |
| Material: | Stainless Steel |
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
Stainless steel electric heating plate is widely used for baking, drying and other temperature tests of samples. It is a necessary tool for biology, genetics, medicine and health, environmental protection, biochemical laboratories, analysis rooms, teaching and scientific research.
★ The heater is made by a special molding process.
★ The working panel is made of high-quality stainless steel.
★ The temperature rise is fast and uniform, easy to operate and safe to use.
|
Model |
Voltage |
Power(W) |
Heating Area(mm) |
Size(mm) |
Accuracy |
Temp. Range |
Weight(Kg) |
|
YHP-DB-2A |
220V, 50Hz |
1000 |
300*200 |
300*200*170 |
±1-2ºC |
RT-300ºC
|
6 |
|
YHP-DB-3A |
1500 |
350*220 |
350*220*220 |
8 |
|||
|
YHP-DB-4A |
2000 |
400*300 |
400*300*220 |
10 |
|||
|
YHP-DB-5A |
2500 |
500*400 |
500*400*220 |
15 |
|||
|
YHP-DB-6A |
2800 |
600*400 |
600*400*220 |
28 |
1. When using this type of electric heating device, it must be noted that its continuous operating temperature should be less than 240ºC, and the instantaneous temperature should not exceed 300ºC.
2. The silicone electric heating device can work and be pressed, that is, use the auxiliary pressure plate to make it close to the heated surface. At this time, the heat conduction is good, and the power density can reach 3W/cm2 when the temperature of the working area does not exceed 240ºC.
3. The allowable working temperature is less than 150°C under the adhesive installation condition.
4. In the case of dry burning in the air, the power density should be less than 1W/cm2 due to the temperature resistance of the material; in non-continuous working conditions, the power density can reach 1.4W/cm2.
5. The working voltage selection is based on the principle of high power-high voltage, low power-low voltage, special needs can be listed
6. A power supply that meets the requirements of the instrument must be used. The power socket should be a three-hole safety socket and a ground wire should be installed.
7. First use will produce micro smoke, which is normal.
8. During use, prevent the heating medium from overflowing the vessel and flowing into the cabinet to damage the electrical appliance.
9. If there is a failure during use, the power supply should be cut off and then repaired.
10. Empty burning is prohibited.
){kind=link}